Zone:
Welcome
Welcome to the Laser Zone! This zone is solely for the laser cutter.
Trainers
- See Ryan for training.
Getting Help
- The Trainers will answer questions on the operation of the laser cutter.
- If you have a concern, just ask, it's cheaper then replacing equipment!
- Designing work is not actually included, but maybe we can point you in the right direction!
Safety Rules
- Only cut these materials
- Keep area clear of debris, cutoff pieces and other hazards.
- Take your time. Accidents happen because someone is in too big of a hurry.
- Think about what you are doing. If something seems unsafe, it probably is.
- If you see flames between the lens and your work, stop the equipment until you can isolate the issue.
- If your work is catching on fire, melting, or similar stop the equipment until you can isolate the issue.
- Leave the space as clean as you found it. If you find it in a messy state, please contact Ryan or Zack describing the mess, date, and time, and then please be extra awesome and clean up after those before you.
Operating Procedures
Startup (Cold start)
- Power on the machine from the back left toggle switch
- You should expect machine to startup and calibrate the head to 0,0 (top left) while the bed goes to the bottom (may require the lid interlock to start this sequence.)
- Turn on the circuit breaker for SP500
Shutting Down
Common Troubleshooting
Doesn't seem to trigger laser
Solution 1: Open and Close the Lid Interlock
If you turn on the laser unit and prepare your work, then turn on the circuit breaker for the tube at the last second, you simply need to open and close the lid.