No edit summary |
No edit summary |
||
| Line 7: | Line 7: | ||
=== Trainers === | === Trainers === | ||
* Ryan | * See '''Ryan''' for training. | ||
=== Getting Help === | === Getting Help === | ||
* The Trainers will answer questions on the operation of the laser cutter. | * The Trainers will answer questions on the operation of the laser cutter. | ||
* Designing work is not included | * If you have a concern, just ask, it's cheaper then replacing equipment! | ||
* Designing work is not actually included, but maybe we can point you in the right direction! | |||
=== Safety Rules === | === Safety Rules === | ||
Revision as of 02:33, 15 May 2023
Zone:
Welcome
Welcome to the Laser Zone! This zone is solely for the laser cutter.
Trainers
- See Ryan for training.
Getting Help
- The Trainers will answer questions on the operation of the laser cutter.
- If you have a concern, just ask, it's cheaper then replacing equipment!
- Designing work is not actually included, but maybe we can point you in the right direction!
Safety Rules
- Only cut these materials
- Keep area clear of debris, cutoff pieces and other hazards.
- Take your time. Accidents happen because someone is in too big of a hurry.
- Think about what you are doing. If something seems unsafe, it probably is.
- If you see flames between the lens and your work, stop the equipment until you can isolate the issue.
- If your work is catching on fire, melting, or similar stop the equipment until you can isolate the issue.
- Leave the space as clean as you found it. If you find it in a messy state, please contact Ryan or Zack describing the mess, date, and time, and then please be extra awesome and clean up after those before you.