No edit summary |
No edit summary |
||
| Line 31: | Line 31: | ||
== Software == | == Software == | ||
Trotec Ruby | [[Guides/Ruby|Trotec Ruby]] | ||
* | * | ||
* | * | ||
Revision as of 02:31, 15 May 2023
Zone:
Welcome
Welcome to the Laser Zone! This zone is solely for the laser cutter.
Training
- When Authorized to use tools, it means you have been authorized by a trainer to use the laser. Authorization refers to the unique things that are required of a user at KMS, one knows how to use the tool, maintain it, where parts and tools unique to the tool are kept, and the proper condition to leave it in.
- Full Access allows operators to utilize the equipment without supervision.
- Limited Access allows operators to utilize the equipment once the project setup has been verified.
Office Hours
- 2nd and 4th Mondays of the Month at 6:00 pm to 8:00 pm.
List of Trainers
- See list at the bottom of the page.
Getting Help
- The Trainers will answer questions on the operation of the laser cutter.
- Designing work is not included. If you need help with your design, there will be an additional charge set by the person helping.
Safety Rules
- Only cut these materials
- Keep area clear of debris, cutoff pieces and other hazards.
- Take your time. Accidents happen because someone is in too big of a hurry.
- Think about what you are doing. If something seems unsafe, it probably is.
- If you see flames between the lens and your work, stop the equipment until you can isolate the issue.
- If your work is catching on fire, melting, or similar stop the equipment until you can isolate the issue.
- Leave the space as clean as you found it. If you find it in a messy state, please contact Ryan or Zack describing the mess, date, and time, and then please be extra awesome and clean up after those before you.